Skip to content
Cart
← The DSC Journal

How to proof a wrap at a car door beltline

Check the artwork and film stops along the line below the windows before you approve the side layout.

Vehicle graphics
Davao Sticker Custom

Show the line from the front door to the rear

Take a straight side photo with the windows up and doors closed. Mark the beltline, any molding below the glass, and the section you want wrapped. Add a close photo where the line changes height or meets a mirror or pillar. If the two doors have different trim, identify each piece. Include a view with the doors open if you want to discuss the exposed edge.

Check what happens when a graphic meets the line

Ask for a mockup with the trim and panel gaps visible. Look where lettering or a stripe reaches the beltline. If the design follows it, check whether a rising or falling section changes the appearance of the stripe. Compare a second proof with the detail moved away from the joint before deciding which alignment works.

Separate artwork placement from the film boundary

Ask the installer to mark where the film stops beside the molding and what work they need to confirm in person. Tell them if you plan to replace trim. Keep the artwork proof and coverage drawing together so both show the same doors and side.

Proof any difference between the two sides

If one side has a different mirror base or trim line, ask for its own side view. Compare where the same graphic meets the beltline so the proof shows whether each side needs a separate adjustment.

Repeat the check at pickup

View the wrap from the side and along the vehicle. Check the approved line at the front and rear doors and save photos where the artwork reaches the trim.

For checking graphics across seams, see the wrap graphic seam placement guide.

Request a project quote

Send a side photo and mark the beltline and the design elements that meet it.

Discuss your project →