Davao Sticker Custom
Ask for a proof that shows the film pieces
A clean mockup can hide the lines where separate pieces of film will meet. Ask the installer to mark proposed film joins on a second version. Label those lines separately from the van’s door gaps and body creases. Include both sides and any transition from the side to the back. A long side panel may need a different piece layout from the shorter panels beside it.
Move fine detail away from a proposed join
Review the markups with the logo, lettering, and any repeating pattern visible. Check where a film join meets the narrow stroke of a letter or a stripe with a hard edge. Ask whether the artwork can move enough to keep that detail on one piece. For a photograph or gradient, identify areas where a visible line would distract from the subject and discuss an alternate position. Include a close-up crop of each important join on the proof. At full van scale, a line through an emblem can be hard to spot on a phone.
Ask where the material and panel shape set limits
Have the installer confirm the proposed join after measuring the van. Ask which joins the film width, panel shape, and selected material require. If the proof includes an overlap, ask the installer to show its location and explain how they will follow the film maker’s installation instructions. 3M vehicle film application guidance
Keep the marked copy with your approval
Save the clean artwork and the marked production layout under the same revision. If a panel needs replacement later, the marked copy helps the installer see where a new piece would meet the existing print. Photograph any change to the proposed joins at handover.
For a separate check on how the artwork reads while the door is open, see the sliding van door proof guide.