Skip to content
Cart
← The DSC Journal

How to check PPF handoff when doors have different finishes

Use a door-by-door map to confirm which finish was installed and which instructions apply.

Vehicle protection
Davao Sticker Custom

Bring the approved door list to pickup

Give each door a label by side and position. Put the approved film product and finish beside it. If one door remains original paint or uses older film, identify that too. Walk around the car with the installer and ask them to point out where the piece ends beside each gap or trim line.

Compare neighboring doors under similar light

Look along the side and check the finish against the sample or approval photo. If the finishes are intentionally different, check the exact transition you approved. Open the door if a covered area is only visible from inside. Take a wide photo that shows which doors meet and a close view of the boundary.

Collect the right care instructions for each door

Ask which product guidance applies to each finish and record any different wash timing or approved methods. If a detailer or another driver handles cleaning, share the door map. Keep any spot under review labeled with the door, finish, and date.

Confirm any door repaired after the first quote

If the installer changed a film choice after inspection, ask for the final product and the reason on that door’s line. Compare the old and new scope before signing off. Give the updated diagram to anyone who uses or cleans the vehicle. Label each close-up by door so it remains easy to match to the correct film.

File the approvals by side before leaving

Save the final diagram and photos with the installer contact. If one door needs new film later, use the record to identify the finish before requesting a replacement.

For a finish map across the whole car, see the two-finish handoff guide.

Request a project quote

Send the door list and the finishes you want confirmed at pickup.

Discuss your project →