Skip to content
Cart
← The DSC Journal

What to check at handoff after installing two PPF finishes

Confirm which panels received each finish and keep the approved boundaries and care instructions together.

Vehicle protection
Davao Sticker Custom

Bring the approved finish map to pickup

Ask the installer for a copy of the drawing that identifies each finish by product and panel. Walk around the car with that map and confirm which piece sits beside each other. Check a spot where the finishes meet, then look at the same boundary in the light you used to approve the samples if the conditions allow.

Photograph each finish and their transition

Take one photo showing each finish on its own and a wider view that shows both on the vehicle. Add a close photo of the boundary at a panel gap, trim line, or other fixed landmark. Label the files with the finish and location so a later installer can identify the piece.

Collect the instructions for each product

Ask which care instructions apply to each finish and where they differ. Record the earliest approved wash and any products that need a separate check. If someone else cleans the car, send them the map and instructions so they can match the right method to each panel.

Use a clear finish key for later repairs

Give each finish its own label on the map and use those labels on photos and care notes. If a panel needs replacement later, ask the installer to check that label against the neighboring piece before choosing a film.

Record any open review with the correct finish

If you and the installer agree to review a spot later, record the date, exact panel, and finish. Keep that note with your photos and the job record.

For comparing finishes before installation, see the PPF finish matching guide.

Request a project quote

Send your panel and finish list and mark any transition you want to inspect at pickup.

Discuss your project →