Skip to content
Cart
← The DSC Journal

How to inspect a decal where two cab panels meet

Check each decal edge and the artwork alignment where two truck cab panels meet before deciding what needs correction.

Vehicle graphics
Davao Sticker Custom

Compare the installed join with the proof

Photograph the parked cab from the side and take a close view of the join. Identify the two panels and show the start and end of each graphic piece. Find the approved proof and check where the artwork was supposed to line up. Mark any panel repair, replacement trim, or change that could affect the comparison.

Check alignment and edge condition separately

Look at the graphic from straight on and from the usual approach. Note whether a line appears offset and whether either piece has visible damage. Use measurements from fixed edges instead of judging the gap alone. Ask the installer to inspect the film and surface. Leave any lifted edge in place so they can see its current condition. If the panels were adjusted since the decal went on, show that information to the installer. Check where the approved measurements were taken before comparing the new position.

Confirm the correction before ordering a piece

If one panel moves, have the installer review its normal positions with any trial material removed. Ask whether the proposed correction affects one piece or both. Request a proof that shows the gap and the adjoining graphic. If you are matching older material, compare a physical sample at the truck before approving a replacement.

Record both panel references

Save the wide view, close-up, and measurements with the job. Label which piece is changing and which stays so the installer can match the intended alignment. Take the final comparison photos with the panels shut.

Use the panel gap proof guide if the artwork needs a new layout across a door split.

Request a project quote

Share a full cab view, close-ups of the joint, and the original artwork if available.

Discuss your project →