Skip to content
Cart
← The DSC Journal

How to check body panel gaps on a door decal proof

Mark real door gaps and compare artwork with the doors open and shut before approving graphics across body panels.

Vehicle graphics
Davao Sticker Custom

Mark the exact door split on the proof

Look at the side of the parked vehicle with both doors shut. Ask the designer to mark the actual panel gap on the photo. Photograph it close up where the artwork would cross, including any change in height or angle. A straight reference line on a stock drawing can miss a curved door edge or a difference between front and rear doors.

Keep names and numbers whole

Find any letter, digit, or thin line that sits over the gap. Try moving the line onto one door or splitting separate words at the boundary. If the design uses a wide stripe, ask for a proof showing each piece on its own panel and the visible space between them. Check the alignment with the doors closed.

Open the doors that carry the artwork

Have the installer explain where each piece will finish near the moving edge. Open one door at a time and look for any part of the design that changes meaning or becomes hard to read. Confirm the planned clearance around seals, hinges, and door edges with the installer. Check the other side if the vehicle layout differs.

Mark each piece before the final approval

Save a proof that names each door and shows the gap. Give the installer a fixed starting point on each panel. If a damaged door later needs a replacement piece, use the marked proof to check its position against the graphics beside it. Label any stripe pieces that look alike so the installer can match the front and rear ends.

Use the film seam guide for joins between separate pieces of wrap film.

Request a project quote

Send closed and open door photos and flag any artwork that crosses the gap.

Discuss your project →