Skip to content
Cart
← The DSC Journal

How to choose a decal size for a recessed vehicle door

Measure the usable face inside a door recess and compare a decal within it with a suitable flatter position.

Vehicle graphics
Davao Sticker Custom

Measure the face and mark where the recess begins

Photograph the parked vehicle from the side and at an angle. Trace the recess and mark any handle, trim, and working features. Measure the usable width and height inside the intended area. Ask the installer which part of the surface suits the film and where the piece can end. Keep the measured references on the photo.

Compare a smaller proof with a flatter location

Ask for one actual-size proof inside the clear recess and another on a suitable area nearby. Keep the wording and artwork the same. Check whether the recess hides a stroke from the normal approach. If the small version is hard to read, move the full piece rather than crowding the curve. If the recess is narrow at one end, put that measurement on the photo. Give the printer the narrowest clear width and the line of text it needs to fit.

Review the placement on the parked vehicle

Hold both paper versions against the door, then remove them before operating any hardware. Look straight on and from a corner. Ask the installer to verify the final boundaries on the actual door. If the other side has a different recess or trim, check it before ordering a second piece.

Record the finished size and measured location

Save a close photo showing where the design ends, plus the whole side view. Keep the approved size separate from any larger trial version so the printer cuts the correct piece. Confirm the orientation of the finished piece on the proof. Label the reference points by door.

Use the handle clearance guide if the recess includes a handle or sensor.

Request a project quote

Share the recess dimensions and straight and angled photos of the fitted door.

Discuss your project →