Skip to content
Cart
← The DSC Journal

How to proof a scooter wrap with the seat cover removed

Use photos of the fitted and removed configurations to check the graphic beside the seat and nearby panels.

Vehicle graphics
Davao Sticker Custom

Document the scooter before the part is refitted

Take side and rider views showing the seat area and the adjacent panels. Identify the removed cover and show where it normally sits. Tell the designer whether it will go back on or be replaced. If you have an earlier photo of the assembled scooter, include it and label which view shows the final setup.

Check how much of the artwork is visible after fitting

Ask for a proof showing the cover fitted and one showing the area beneath it. Check where a stripe or logo meets the seat edge. If part of the artwork disappears under the cover, ask the designer to move the main detail to a surface that stays visible. Compare both sides with the same setup.

Agree who confirms the fitted boundary

Ask the installer which surfaces can be assessed while the cover is off and which need a photo or check after refitting. Confirm who handles any removal or access and whether the estimate includes it. If a new part is planned, keep its fit provisional until it can be reviewed.

Save the approved fitted view at pickup

Compare the installed layout with the proof and take a close photo of the seat edge and film stop. Record the final cover reference if it differs from the original. If the cover changes after the first proof, photograph the replacement on the scooter and compare the graphic again. Check which seam or edge now interrupts the artwork. Ask the installer to mark any fitting work separately and keep the revised rider and side views together.

For another scooter layout around retained trim, see the scooter wrap and trim guide.

Request a project quote

Send both seat-area configurations and the planned artwork.

Discuss your project →