Skip to content
Cart
← The DSC Journal

How to approve an SUV wrap around a liftgate spoiler

Check the upper rear artwork and film edges with the spoiler fitted and the liftgate in its normal positions.

Vehicle graphics
Davao Sticker Custom

Use rear and corner views with the spoiler fitted

Take a rear photo and both rear corner views. Show where the spoiler sits above the glass and how it meets the liftgate. Add an open-liftgate photo from a safe place. Mark any light or trim that needs to stay visible and identify any part still due for replacement. Tell the installer whether you want the spoiler considered for wrap or left in its current finish.

Compare the design from below the spoiler

Ask for a mockup showing the fitted part and the complete rear view. Check whether the spoiler hides a stripe or lettering when you stand behind the SUV. Compare a second layout if the graphic looks interrupted. Ask the installer to mark where the film stops around the spoiler, glass, and openings, including any edge you can only see with the liftgate open.

Confirm the scope and access before production

Ask which surfaces the proposed material can cover and whether the installer needs to inspect any narrow gap. If another business will remove or refit the spoiler, agree when the installer needs a current photo. Keep that work separate on the estimate. Ask for the final film and artwork boundaries on the same proof so the scope matches what the designer shows.

Save the final rear position

Label the photo with the spoiler fitted.

Review both liftgate positions at pickup

Use the rear and corner views to check the finished artwork, then open the liftgate to confirm any edge you approved there. Save a close photo of each spoiler end and the final proof with the wrap record.

For planning wrap near another rear window feature, see the offset rear window proof guide.

Request a project quote

Send spoiler and liftgate photos and mark the rear design or wrap boundaries.

Discuss your project →