Skip to content
Cart
← The DSC Journal

Proofing waterproof stickers for a wet tool drawer

Find a visible position in a wet tool drawer and check the sticker through loading, splash, and cleanup.

Tool drawer labels
Davao Sticker Custom

Find what gets wet and what gets scraped

Open the drawer and put the tools in their normal positions. Watch where a wet tool drips and where a handle slides when you pull it out. Mark the low spots that collect water and any raised edge that tools scrape. Put a paper mockup where you want the label and check whether you can read it before moving a tool. Try the drawer front or a divider if the first position stays covered.

Compare two positions in the same drawer

Ask for a sample suited to the drawer finish and the cleaner you use. Apply matching pieces in the proposed area and away from the usual drip path, following the material directions. Photograph the starting edges. Load the drawer as usual and check after wet tools have been taken out and put back. Wipe the drawer as you normally would. Record whether a mark follows a tool path or whether an edge lifts after the wipe.

Use the condition you expect between shifts

Close the drawer after putting the damp tools away as usual. When you reopen it, note any droplets that formed on the inside face or settled on the dividers. Read the IDs with every tool in place, then repeat after the normal wipe and closure cycle. If the sticker under a tool stays wet, compare it with a sample on the inside drawer wall. Keep the drawer finish and sample details with the placement photo.

For testing the print after splashes and cleaning, see the waterproof sticker testing guide.

Request a project quote

Share the drawer surface, the way it gets wet, and where you want the label to sit.

Discuss your project →