Skip to content
Cart
← The DSC Journal

Sizing a logo sticker for a narrow bottle shoulder

Measure the shoulder on a filled bottle and compare small proofs before placing the logo across a change in curve.

Bottle shoulder sticker sizing
Davao Sticker Custom

Mark where the shoulder begins to turn

Set a filled bottle upright and look for the narrow band below the cap and above the main body. Measure it around the front and sides. Put a paper outline there and see where it starts to buckle or turn out of view. Show the printer the bottle material and the area the sticker needs to occupy. Keep the mockup clear of the cap or opening parts.

Compare two sizes on the same shoulder

Print the logo at both proposed sizes and fit the samples on matching bottles. Look at the outer letters from the front and from the usual angle on a shelf. If the wider version turns away from the reader, try a shorter mark rather than moving the artwork farther into the curve. Ask the printer for a sample suited to the shoulder shape and check how the ends sit after application.

Keep a reference for the smallest bottle

Apply a printed sample at the same position on several bottles. Check whether the top edge stays level and whether staff can align it without measuring each time. Save a close photo and a straight-on photo with the approved dimensions. If the same logo goes on a wider bottle, verify that version separately before using one cut for both.

Check the bottle inside its intended tray or sleeve. A mark that reads from the front on a table may sit too high or low when a neighboring bottle blocks the view.

See the tapered bottle label proof guide for a related check.

Request a project quote

Send the bottle and show the narrow shoulder area where the logo should sit.

Discuss your project →