Skip to content
Cart
← The DSC Journal

How to position a small logo on a vehicle mirror housing

Check the housing’s shape, moving positions, and visibility before placing a small logo on a confirmed surface.

Vehicle graphics
Davao Sticker Custom

Photograph the housing as it sits on the vehicle

Take front and angled photos while the vehicle is parked. Mark the housing finish and identify any light, camera, sensor, seam, or cap. If the mirror folds, show the normal positions with the mockup removed. Ask the installer to confirm which surfaces can take the proposed film and keep all functional parts clear.

Find the area where the whole logo can read

Ask for a full-size paper proof within the clear face. Hold it against the parked housing and look from the normal approach. A small logo may lose detail near a curved edge. Try a simplified approved version or another suitable panel if the mark cannot stay complete in the available area. Ask a fresh reader to identify the logo without telling them what it is. If only one part of the mark is visible from the usual approach, try a different placement or another approved version.

Check both sides before copying the placement

Compare the driver and passenger housings if both will carry a piece. Keep lettering in normal reading direction on each side. If a fitting or trim differs, give that side its own proof. Remove any trial material before operating the mirror or driving.

Record the exact position and orientation

Save the approved size and measurements from fixed points. Label the piece by side and housing type. Give the installer a close photo showing the planned boundaries. If the cap is replaced, confirm the new fit before ordering again. Record which way the small mark faces on each housing.

Use the hardware clearance guide for a separate rear fitting.

Request a project quote

Share front and side photos of the housing and show any lights, cameras, or moving edges.

Discuss your project →