Davao Sticker Custom
Photograph the bumper and adjoining panels
Start with a straight photo, then take a view from each corner. Mark the trim inserts, panel gaps, reflectors, sensors, lights, and tow access. Show which surfaces are painted and point out any repairs or replacements. Ask the installer to confirm the planned materials for each surface before treating an insert or recessed area as part of the wrap.
Compare two boundaries in the proof
Ask for a version that follows a feature such as a crease and one that uses the edge of a separate trim piece. Include the fender or quarter panel on the proof so you can see where the line leads. If a boundary crosses a deep curve, ask whether another position would keep the intended shape clearer from the corner.
Check where the paint will still show
Hold samples next to the bumper and review the proposed break from the rear or front and both corners. Note any strip of original paint visible beside the trim or near the wheel opening. Ask the installer to mark areas they will leave clear for equipment, operation, or access.
Approve both corners together
Save the exact end points on each side of the bumper and confirm that the quote uses the same coverage. If the two sides have different openings, keep a labeled close-up of each side with the proof. If the front and rear bumpers use different boundaries, give them separate proof sheets and review both with the same samples in daylight. Note which color goes on each side of the line.
See the two-tone wrap design guide if the same break continues across the body.