Skip to content
Cart
← The DSC Journal

How to set PPF coverage for an SUV with splash guards

Show how each guard sits next to the painted arch and lower body before deciding where the film should end.

Vehicle protection
Davao Sticker Custom

Record the fitted guards and the usual road wear

Take side photos of the SUV and close views of the front and rear guards. Mark where each guard meets painted bodywork. Note where you still see spray or road grime after a typical trip. Label any guard that was added later and include the part information if you have it. Show both sides if they differ.

Separate the guard from the paint you want covered

Mark the painted arch, rocker, or door areas individually. Ask the installer to draw the proposed film stop beside the guard and show what remains exposed. If an outline extends behind a fitted part, confirm what the installer needs to inspect before pricing. Compare the areas you use most before approving all four corners.

Discuss what happens if the guards change

Tell the installer if another guard is planned or if the current part comes off for service. Ask whether the future part changes the footprint. If the film work requires moving it, confirm who will handle that and how the estimate accounts for the work.

Compare both sides after a typical drive

If the splash pattern is different on the two sides, point it out before requesting a matched outline. Ask the installer to show any intended differences on the estimate. Mark the side you check most often and the route that leaves those marks.

Keep a photo of the fitted boundary

Review the approved line at pickup from the same side views. Save a close photo of each covered corner and note which guard was fitted. Use the record if another shop later changes the part.

For choosing painted wheel opening coverage, see the wheel arch coverage guide.

Request a project quote

Send front and rear guard photos with the painted surfaces you want reviewed marked.

Discuss your project →