Skip to content
Cart
← The DSC Journal

How to review a PPF sample on light metallic paint

Use several viewing angles to compare a film sample with light metallic paint before approving the finish.

Vehicle protection
Davao Sticker Custom

Choose a panel and a representative sample

Pick a body panel you see often, such as a door or front fender. Tell the installer the paint color if known and mention any nearby repaint. Ask them to show the exact proposed film over a representative painted surface. Ask what the sample is mounted on and whether they can show it beside the car.

Follow the color from straight on to an angle

Compare the sample in open shade and brighter daylight. Look at the surface straight on and then from the side while keeping the sample beside the panel. Pay attention to any color difference you see as the light changes. Ask someone else to stand at your usual viewing point and describe what they can see.

Check a possible film line in the same light

Ask the installer to draw the film edge on a photo of the panel. If a partial piece ends across the painted face, compare that position with a full-panel version. Note the angle and distance at which you can see the boundary and decide which version you want priced.

Compare the sample against more than one panel

If the door and fender look different in your normal viewing light, note which one the sample should match. Check the proposed film beside both before ordering the whole job. Record which panel you used for the final approval.

Record the sample and the chosen boundary

Keep the film product and finish with the photo and drawing. If you review a replacement sample later, repeat the same viewing positions before approving it.

For comparing finishes on adjacent panels, see the PPF finish matching guide.

Request a project quote

Send daylight photos of the panel and tell us where you want to compare the sample.

Discuss your project →