Skip to content
Cart
← The DSC Journal

How to plan rear bumper PPF for a work vehicle

Map the contact points from daily equipment handling and quote the painted bumper separately from steps, trim, and hardware.

Vehicle protection
Davao Sticker Custom

Watch how a normal load moves

Park the vehicle in the area where your crew usually loads it. Have someone describe how cases, tools, or supplies travel from the ground to the cargo bay. Mark where an item passes near the bumper, rests on a painted ledge, or brushes an outer corner. Take photos with the rear doors or tailgate both open and closed so the installer can locate each spot.

Separate the paint from work hardware

Mark which parts of the bumper are painted and which are a step, grip surface, tow fitting, or separate protector. Point out any sensors, lights, or labels nearby so the installer can check what needs to stay clear. If the vehicle uses a ramp or loading aid, show its normal position and identify where it touches the vehicle.

Price the high-contact areas before adding others

Ask for a drawing that covers the spots your crew identified. If different shifts use the vehicle differently, ask one person from each shift to review the drawing. Request separate prices for the painted loading edge and each bumper corner you want considered. Ask the installer what would change if you add a piece later.

Record the boundary for the people who use it

Save the approved drawing and take photos at pickup. Share them with the crew so they can point to the exact area if they notice damage during loading. Give the vehicle lead a copy of the scope and ask them to record the location and date of any new mark. Use the same labels as the panel drawing.

For a loading ledge on a passenger vehicle, see the luggage loading sill guide.

Request a project quote

Send a photo of your usual loading setup and mark each painted contact area.

Discuss your project →