Skip to content
Cart
← The DSC Journal

How to inspect PPF before a shared vehicle enters service

Create a starting condition record and give each driver the same coverage and reporting instructions.

Vehicle protection
Davao Sticker Custom

Collect the film record before handing over the keys

Find the product, finish, installation date, and panel drawing for the vehicle. Check which pieces are still under review and which areas were left exposed. Take wide photos of both sides and the rear, then label any close views of edges or marks staff need to recognize. Save these as the starting condition.

Walk through the usual use with the driver lead

Show where staff enter, load equipment, and wash the vehicle. Point out which painted areas carry film and where it stops. If staff use different doors or parking sites, identify the coverage near those points. Ask the installer to review any concern before the first service shift if needed.

Assign one person to handle care and reporting

Give drivers the approved product instructions and the installer contact. Tell them how to record a change with a wide photo, close photo, date, and panel label. Ask the driver lead to share the same information with the wash provider. Note any date when the installer wants another look.

Keep the starting photos easy to find

Store the coverage drawing and images with the vehicle identifier. If a driver reports a mark later, match the area to the starting photo before asking the installer about it. Record the response in the same file so the next shift can see it.

Check the record before a replacement vehicle goes out

Use the new vehicle’s own film instructions and photographs rather than copying the old setup. Ask the driver lead to sign off on the starting photos and confirm that the care instructions are available to every regular driver.

For a handoff across several vehicles, see the multi-car PPF handoff guide.

Request a project quote

Send the vehicle identifier, film record, and any areas you want inspected before service.

Discuss your project →