Skip to content
Cart
← The DSC Journal

How to request PPF for a two-tone roof

Mark the roof color break and compare film outlines without losing track of the finish you want on each surface.

Vehicle protection
Davao Sticker Custom

Map the colors and the materials

Take photos of the front corners, the roof sides, and the rear from ground level. Mark where the roof color stops at the pillars and where any trim or glass interrupts it. Tell the installer whether each visible color is paint, vinyl, or unknown. If you know that part of the roof was repaired or wrapped, send any product or repair details you have.

Decide whether the film should follow the color break

Ask the installer for an outline over the roof color and another if your intended coverage extends into a neighboring painted area. Look at where a film line would sit next to the color break. Check the view from beside the car and from the front corner. If a narrow band of one color would remain exposed, ask how that might look next to the filmed area.

Compare samples on both colors

Review the proposed film on representative samples of the two colors in the same light. Ask which product and finish are included and which surfaces need separate assessment. Check where the installer would end the piece near roof rails, trim, or a removable panel.

Keep the outline with the finish approval

Save the approved film name and drawing with the quote. Ask the installer to show the agreed boundary at pickup, especially where the color break turns down toward a pillar. If you later remove or replace a roof accessory, use the drawing to check whether its footprint crosses the film. Keep the finish approval with both roof color references.

For comparing samples beside a different finish, see the PPF finish matching guide.

Request a project quote

Send photos showing both roof colors and mark the areas you want covered.

Discuss your project →