Skip to content
Cart
← The DSC Journal

How to request PPF for a roof with raised moldings

Show the molding profile and compare the film stops beside the roof channels and exposed paint.

Vehicle protection
Davao Sticker Custom

Photograph the roof edge from safe positions

Take front and side views from ground level. Mark where the raised molding starts and ends and include the painted strip beside it. Show any rail or other accessory you can see safely. Tell the installer whether the molding is original, replaced, or part of a planned roof change.

Decide whether the roof or narrow edge is in scope

Ask for an outline showing the main roof area and the painted strip beside the molding. Check where the line ends at the front and rear. If you want the installer to assess a painted area beyond the molding, label it separately. Ask where the shop needs to inspect before confirming the piece.

Discuss access without assuming the molding comes off

Ask whether the film can stop at the fitted molding and what would change if the installer recommends moving it. Confirm who would handle that work and what it adds to the estimate. Mention any future rail fitting that could meet the film line.

Compare the line with the roof viewed from the side

Ask the installer to show the area between the raised molding and the roof color or trim line. If two proposed stops leave different amounts of paint visible, compare them using the same side photo. Have the installer mark any spot where the shape or an accessory needs a closer fit check before the estimate is final.

Review the proof and finished edges from the same positions

Save the marked side and front views. At pickup, ask the installer to point out the line and show photos of any area you cannot safely see.

For protecting only the painted strip above the windshield, see the roof leading edge guide.

Request a project quote

Send safe roof-edge photos showing the raised molding and nearby accessories.

Discuss your project →