Skip to content
Cart
← The DSC Journal

How to plan PPF for painted fog light surrounds

Mark the painted trim around each fog light and check where the film would stop beside the lens and bumper.

Vehicle protection
Davao Sticker Custom

Show the surround as a separate part

Take a straight front photo, then a close view of each fog light area. Label the painted surround, lens, grille, and neighboring bumper. Use a side angle to show whether the surround sits back from the bumper or meets it along the same face. Tell the installer if one side has a replacement bezel or a different finish. A labeled photo helps separate the trim you mean from the bumper around it.

Ask which painted faces are in the outline

Mark the areas you want covered, such as the face visible from the front and the painted edge that turns into the recess. Ask the installer to draw the line nearest the lens and any other feature the vehicle maker says should stay clear. If a tight corner may change the outline, ask where the installer needs to inspect it before making the piece.

Compare both sides with the bumper proof

Ask for the left and right outlines on one page. If the bumper will also get film, look at where each surround piece meets that layout. Ask the shop to quote the surrounds separately if they require their own pieces or trim work.

Use close photos to check the small edges

At pickup, look at each inside corner and the joint with the bumper. Save a close photo of both sides with the approved coverage drawing. If the surrounds sit at different depths, ask the installer to note that difference on the drawing. Check the finished line from the front and from beside the bumper.

For other bumper openings, see the front bumper cutout guide.

Request a project quote

Send photos of both fog light surrounds and mark the painted faces you want checked.

Discuss your project →