Davao Sticker Custom
Show the lip from the front and both corners
Take photos once the part sits in its intended position. Identify the lip brand or part number if available and describe the surface finish. Mark its seam with the bumper, end caps, and any visible hardware. If it is a multi-piece lip, show where the pieces meet. Tell the installer whether any part still needs adjustment.
Separate the bumper outline from the lip outline
Ask for a drawing of the painted or finished lip on its own and a wider view showing how the bumper film meets it. Mark where the lip turns under the car or around an end. Ask which faces the installer can assess without lifting the vehicle and which they need to check in person. Have the installer identify any hardware that needs access later.
Resolve the fit before cutting the film
If the lip will move during another job, coordinate the fitting and film appointments. Ask who would refit the part if the installer needs access and whether that work is included. If a gap or seam changes during the fitting, review the outline again against the final part before you approve it.
Check the edge in the normal view
At pickup, check both ends and the seam with the bumper. Save the wide photo and the close views with the agreed outline. Ask the installer to identify any fastener you should be able to reach after fitting the film. Mark it on the drawing and keep a close photo of the clearance around it with the job notes.
For the bumper itself, see the front-end coverage guide.