Skip to content
Cart
← The DSC Journal

How to check PPF fit beside a raised hood badge

Compare where the film ends around the badge height and mounting footprint before approving the hood proof.

Vehicle protection
Davao Sticker Custom

Show how the badge sits above the hood

Take a full hood photo, then a side-angle close-up that shows how the raised badge meets the painted surface. Mark the nearest body line or trim. Tell the installer whether it is the original badge or an accessory, and whether a different badge is planned. Show any existing film edge in the same area.

Review the painted line from the front corner

Ask for a drawing showing where film would stop with the badge in place. Check whether a narrow gap or border remains visible around it. If the installer suggests moving the badge, compare a second outline showing what the line would look like after refitting. Ask what part needs a closer inspection.

Discuss the fitting work before deciding

Ask who handles removal or refitting, and what work the quote includes. If another shop will fit a new badge later, show the proposed footprint and ask whether the current piece would need a different boundary. Keep any hardware work separate from the film estimate.

Use a fixed landmark to confirm placement

Ask the installer to mark the badge and film line relative to a hood seam or crease. At pickup, compare that mark with the actual hood and take a close photo showing the height and the film stop. Keep both views for any future change.

Check the appearance from standing height too

A close photo shows the gap, but your normal view helps you decide whether the exposed line is one you want to approve. Keep that viewing position in the approval notes beside the drawing.

For planning the overall hood outline, see the hood edges and seams guide.

Request a project quote

Send a side-angle badge photo and a wide hood view.

Discuss your project →