Skip to content
Cart
← The DSC Journal

How to plan PPF around a spare wheel mount

Map the painted area around the fitted carrier and record what must remain clear before the installer sets the film boundary.

Vehicle protection
Davao Sticker Custom

Show the whole mount in its normal position

Take rear and corner photos showing the spare, carrier, and neighboring paint. Mark the fitted hardware and any painted area you want protected. If you already have a photo with the wheel off, show where the carrier meets the paint. Tell the installer whether the setup is original or added later.

Compare the planned piece with the mount footprint

Ask for a drawing of the painted area with the carrier in place. Check which edge remains visible beside it and which areas the installer needs to see in person. If the carrier swings or changes position, show its normal setup so the installer can identify the parts that need clearance.

Agree on responsibility for any access

Ask whether the installer needs the spare or a cover moved and confirm who will handle it. Tell them if the mount is due for replacement or adjustment. If the fit can still change, ask which part of the estimate remains provisional. Keep the mount work separate from film coverage.

Record the finished boundary for service

At pickup, check the film line with the carrier fitted. Save a close photo that locates the boundary beside a fixed landmark and a wide view of the setup. Give the next technician that record before the mount is serviced or moved.

Include any second configuration in the final record

If you sometimes drive with a different cover, save its fitted photo beside the approved view. Use the matching photo to ask whether the same film boundary applies to both setups. Note any fitted hardware that changes the view.

For the moving rear panel around a spare, see the painted spare wheel door guide.

Request a project quote

Send rear and corner photos showing the spare wheel carrier and nearby paint.

Discuss your project →