Skip to content
Cart
← The DSC Journal

How to approve PPF for one panel of a two-tone car

Confirm the finish and outline for the selected panel while the adjoining color remains exposed.

Vehicle protection
Davao Sticker Custom

Identify the panel and the original color break

Take a full view showing both colors and a close view of the panel gap. Mark the single panel you want covered and identify any original paint or older film on its neighbors. Tell the installer if either color was repainted. Choose the angle from which you most often see the two colors together.

Compare the sample beside the paint that will remain exposed

Ask for the exact film over a representative painted surface. View it beside the selected panel and its neighbor in daylight and shade. Look for any difference you care about in color or reflection. Ask whether a full or partial piece changes where that difference becomes visible.

Approve the scope by panel

Have the installer show the film stop at the color break and nearby trim. If you are leaving the other panel exposed, ask them to note that on the quote. Check any edges that require closer assessment and whether an existing neighboring piece affects the outline.

Keep the finish decision with the installation record

Save the sample reference and the photo you used to approve it. At pickup, check the finished panel against the exposed color in similar light. Photograph the whole transition and save a close view of the approved edge so a future installer knows which panel received film.

Check for a later addition before signing off

Ask whether covering the neighboring panel later would require changes to the first piece. Keep that answer with the drawing. Ask for a separate sample review if you later decide to use a different finish on the neighboring paint.

For comparing a sample at the color break itself, see the two-tone film sample guide.

Request a project quote

Send photos of the panel and its adjoining original color.

Discuss your project →