Davao Sticker Custom
Trace the perforation around the assembled sleeve
Fit the sleeve onto the product and mark where the tear starts and ends. Identify which section the customer removes and which stays on the pack. Place the label mockup on a panel that supports its intended job. If it carries information someone needs after opening, put that information on the section that stays. Mark a finger tab or arrow that the sticker needs to clear. Repeat the check on any other size that uses the same artwork.
Open a printed sample the usual way
Apply a sample to the sleeve at the intended packing step. Give it to someone who has not seen your layout and watch where they begin pulling. Check that the sticker leaves the perforation accessible and that no edge catches as the sleeve separates. Read the remaining copy afterward. If the design needs to bridge the tear line as a seal, test that version separately and tell the printer what should happen on opening.
Give staff a reference they can see while packing
Keep an intact and an opened sample beside each other. Mark the approved sticker position relative to a fold or printed edge. If the sleeve can slide during assembly, check the sticker on a few packs before opening a fresh bundle of labels.
Ask the packer to check an unmarked sleeve against the approved example before applying labels. If the tear tab moves between suppliers, update the example for that sleeve.
For testing the sleeve as it slides onto the product, see the box sleeve label proof guide.