Skip to content
Cart
← The DSC Journal

How to proof a motorcycle wrap on removable side covers

Check artwork with each cover on the bike and agree where the film stops before the covers go back into service.

Vehicle graphics
Davao Sticker Custom

Make a photo set for both covers

Photograph each side cover while it is fitted and include the neighboring tank, seat, and frame. If a cover is already off, take a photo of the reverse and the edge from a safe position. Mark the clips and the places you grip when taking it off. Identify any cover that has been replaced or has a different finish. Tell the installer how often you need to remove it.

Proof the design with the covers fitted

Ask for a mockup showing both sides of the bike. Check how a stripe meets the tank or another graphic across the panel gap. Keep names or numbers within the area visible with the cover fitted. Ask the designer for one image that shows the complete shape of each printed piece and the position of its artwork relative to the cover’s front and rear edges.

Review access and the film boundary

Ask the installer where the film ends beside the clips, grip points, and areas that contact neighboring parts. Agree who will remove and refit the covers if the work needs it. If you want a second set of covers to match, have the installer inspect those parts before carrying over the layout.

Keep the notes for later removal

Save which cover is left or right and ask the installer to point out the film edge near the grip area. Share that photo with anyone who services the bike.

Save both views at pickup

Check the installed design and the edges you can see when the cover is off. Keep the photos by side with the approved proof.

For a design that continues beside exposed tubing, see the motorcycle wrap planning guide.

Request a project quote

Send fitted and removed views of each side cover and mark the pieces you handle most often.

Discuss your project →