Skip to content
Cart
← The DSC Journal

How to match lettering height on both sides of a van

Use repeatable references and paired proofs to keep van lettering visually aligned when the sides have different trim or openings.

Vehicle graphics
Davao Sticker Custom

Pick a reference that exists on both sides

Photograph the parked van from each side at a similar camera height. Identify a trim edge or body line you can measure on both sides. Ask the designer to mark the lettering baseline relative to that feature. If the line rises or stops at a door, choose a second reference the installer can find.

Compare where the same height fits

Place the same wording and letter size on both proofs. Check the sliding door, fuel door, handle, and trim on each side. If one side leaves less room, try moving both lines to a height they share. If that fails, compare a small adjustment on one side and document why it reads as part of the same vehicle. If the van uses different messages on each side, align the first line or logo rather than the outer edges of the full designs. Ask the designer to mark which element sets the height.

Check two paper proofs on the same van

Hold the samples at the marked height and walk around the front or rear of the parked van. Ask someone to compare the lines without seeing the measurements first. If one line appears higher beside different trim, check the actual reference and revise the layout if it improves the match.

Give the installer two measured locations

Record the letter height and the distance from the baseline to a fixed point on each side. Keep both photos and side labels with the final proof. Label the measuring points on the photos so a different crew can repeat the setup.

Use the full-size lettering test to choose the size before matching the positions.

Request a project quote

Share photos of both van sides and identify the line that should sit at the same height.

Discuss your project →