Skip to content
Cart
← The DSC Journal

How to align pickup decals around side moldings

Use the fitted molding and two fixed references to align pickup decals without crowding the trim or interrupting the design.

Vehicle graphics
Davao Sticker Custom

Map the molding on the fitted pickup

Take side and corner photos with the doors shut. Mark where the molding starts, ends, and changes height. Measure the clear area above or below it and show the handle and gap. Ask the installer to confirm the surface and which features need clearance. Check the other side rather than assuming both moldings sit in the same place.

Compare a shared visual reference

Ask for a proof with the lettering parallel to the molding and one aligned to a fixed body edge. Keep the art size and wording the same. Check the gap between the design and trim at both ends. If the molding turns or narrows, keep the important words on one clear face. If the new artwork uses a stripe as well as words, keep the stripe separate in the proof. Check whether the lettering still looks aligned when an adjacent panel opens.

Read the proof from the usual approach

Hold the actual-size paper on the parked truck. Look from straight on and a rear corner. If the molding makes one end appear crowded, shift the whole piece and compare again. Remove the paper before opening a door or driving. Ask the installer to verify the approved film boundary.

Save the measured reference for each side

Record the size, orientation, and distances to the molding and fixed edge. Label the paired proof photos by side. Ask the installer to mark the measured reference on the final photo before repeating the placement. Date both side photos after fitting.

Use the body crease alignment guide if the artwork also follows a panel line.

Request a project quote

Share straight and angled photos of the moldings on both sides.

Discuss your project →