Skip to content
Cart
← The DSC Journal

How to fit a logo decal around a service box vent

Mark the fitted vent and its access area before choosing a position that keeps the complete logo clear.

Vehicle graphics
Davao Sticker Custom

Identify the vent before laying out the mark

Photograph the parked service vehicle and the side of the box. Mark the vent openings, trim, fasteners, and nearby doors. Ask the owner or maker which areas need clearance and show that information to the installer. Keep the vent, labels, and access clear. Measure the suitable area beside it.

Compare the logo above or beside the vent

Ask for the same complete mark in two positions on clear surfaces. Show the vent on both proofs. If a corner of the logo looks too close to the opening, try a shifted position or an approved smaller version. Check whether staff need to read it from a side or rear approach. If the vent sits beside a door that opens during service, show that view as well. Ask the installer whether a fixed area will keep the full logo visible without using the door.

Use the fitted box for the parked review

Hold a paper proof on the approved area and look from the normal approach. Remove it before opening doors or using any equipment. Ask the installer to check the film, surface, and boundary on the actual box. If a second box has a different vent, measure it separately.

Keep the approved clearance photo

Record the fitted box, final dimensions, and fixed reference points. Give the printer the exact piece position for a future replacement. Ask the owner to verify the selected surface and keep the vent close-up with the final fitted photo. Confirm the approved position again before ordering the replacement piece.

Use the rear vent decal layout guide for a separate check on the vehicle body.

Request a project quote

Share wide and close photos of the fitted service box and vent.

Discuss your project →