Davao Sticker Custom
Choose where someone should read the design
Stand by the parked vehicle at the angle where you expect people to see the fender. A decal across the crown can look narrow when you view it from the side. Hold a paper version against the fender and walk around it. If the first or last letter disappears from your chosen view, move the text to a shallower section or shorten the line.
Show where the fender changes direction
Take a side photo and another from above. Add one close view showing the crown, the area that curves around the wheel, and any raised edges or bolts. Mark the available length along the intended area with a flexible tape and include a photo of how you measured it. The installer can use the photos to identify which parts to check in person.
Compare one piece with a split design
If the artwork crosses a curve in two directions, ask whether the proposed film can conform there. Review a shorter design that stays on the shallower section and a version with separate accents around it. Keep text and fine lines away from the sharpest curve. Ask the installer to follow the film maker’s guidance for the specific surface and film. 3M vehicle film application guidance
Approve the shape on the actual fender
Mark the centerline and the distance to a visible edge or fastener on the proof. Check that the piece clears hardware and ends where you expect. If you're decorating several vehicles, start with one fender and confirm that the others have the same shape before repeating the cut. Have the installer confirm whether the approved footprint fits between the trim and the wheel opening before cutting the run.
For other pieces in the same graphics kit, start with the motorcycle panel template guide.