Skip to content
Cart
← The DSC Journal

Comparing sticker finishes on a pearl packaging sleeve

Inspect how the sticker and pearlescent sleeve reflect light together, then compare the mounted samples before choosing a finish.

Pearl sleeve finish proofs
Davao Sticker Custom

Show the effect you want the sleeve to retain

Fit the sleeve on the product and tilt it under the display light. Mark where you want the sticker and which part of the pearl finish should remain visible. Request the same artwork on the finish options you want to compare. If one uses clear film and another uses opaque stock, record that difference as well. Use sleeves from the actual batch rather than judging from a photo.

Compare the samples in the same part of the sleeve

Apply each sample to an equivalent spot on separate packs. Look straight on, then tilt the packs until the pearl effect becomes visible. Read the smallest word at both angles. Note whether the sticker creates a dull patch, reflects light across the name, or changes how visible the sleeve finish looks. Swap the packs on the shelf to rule out a difference in the lighting position.

Choose the finish with the assembled pack in view

Slip the labeled sleeve onto the product and check that the chosen finish still looks right when the sleeve bends. Keep the approved sample beside an unmarked sleeve. Record the viewing angle and finish on the proof. If the pack goes under a spotlight at one store and a diffuse light at another, compare both before choosing a single finish for all packs.

If the sticker and sleeve both catch the same highlight, rotate the assembled pack and compare the point where their reflections overlap. Use that angle to check the preferred sample again.

See the display lighting finish guide for a related check.

Request a project quote

Send a sleeve sample and tell us how the finished pack is displayed.

Discuss your project →