Skip to content
Cart
← The DSC Journal

Comparing print durability on shared equipment tags

Run matching tag samples through an issue, return, and cleanup cycle and check which IDs remain readable.

Shared equipment tags
Davao Sticker Custom

List what touches the tag during a shift

Watch equipment go out and come back. Mark where fingers, gloves, storage racks, or adjacent gear contact the tag. Record which surfaces staff wipe and the cleaner they use. Point out the smallest line or ID that needs to stay readable. Ask the printer for samples suited to those conditions and identify the same wording or code to compare across each option.

Test matching samples on the same routine

Apply the samples to equivalent tags or units according to the material directions. Keep one unused reference. Have staff check the ID on issue and return, then handle and clean the tags as they normally would. Use the same number of repetitions for the samples. If an equipment tag sees a rougher route than another, note that separately so you can compare like conditions.

Record readability and wear independently

Read the printed code before inspecting the edge. Photograph any scuff and record where it crosses the artwork. Check whether the same spot rubs a handle or rack on both samples. If one sample holds up better, record the print surface and protective finish for the next order. Keep the unused reference beside the tested tags. If staff scan the tag, test the code before and after the same handling cycle. Record a visible scuff separately from a failed scan so the printer knows which issue to address first. Use the scanner staff carry during a shift.

For comparing protective finishes on the print, see the laminate selection guide.

Request a project quote

Share your tag material, cleaning routine, and how people handle the equipment between uses.

Discuss your project →