Davao Sticker Custom
Give both installers the same vehicle and fitting details
Record the vehicle model and trim and share the planned camera position with the accessory and film installers. Use a close photo of the proposed position and a wider view showing the panel. Ask the camera installer which areas need access for mounting and future service. Mark any position they still need to confirm.
Decide which job determines the final outline
Ask both installers whether the camera fitting or the film work should happen first for this configuration. Have the camera installer confirm which areas must stay clear under the relevant instructions. Ask the film installer to show where coverage would stop. If neither can confirm the boundary from a photo, schedule an inspection before approving the film.
Keep the drawing current if the position moves
Put the approved camera location and film outline on one marked photo. If the installer proposes another position, ask them to update the drawing and tell the other shop before the next appointment. Record who approves the change so the camera layout and film proof use the same revision.
Check the finished arrangement with the people who fitted it
Compare the film edge with the drawing and ask the accessory installer to confirm the camera installation and any required checks. Keep photos and the agreed instructions with the vehicle records so a later service visit can locate the film edge and camera fitting.
For a rear fitting, mark the planned camera position and any part a technician needs to remove later. If the mounting position moves during assessment, have both shops sign off on the same updated photo before the film is cut.
For an existing vehicle configuration, see the PPF sensor cutout guide.