Davao Sticker Custom
Mark what belongs to the tray and what belongs to the sample
Give the tray a fixed ID and keep the sample or batch name on the temporary label. Put the mockup where someone can see it with samples in place. Show the printer which finish the adhesive touches, including any coating or molded texture. Tell them how long a label usually stays on the tray and how staff clean it between assignments. Keep a spare tray for the test.
Recreate a full sample handoff
Apply the sample as directed and load the tray. Read the ID when you pass it to the next person and check whether a hand or an adjoining tray rubs the edge. Leave the label for the full assignment before peeling it. Use the removal method approved for the material and inspect the area for residue or a visible change in the finish.
Check a second assignment on the same tray
Clean the tray as you normally do, then apply a fresh label in the same position. Read it with the tray loaded and remove it after the intended interval. Compare the result with an unused tray. Save the material and removal instructions with a photo of the approved position. Mark where staff should place the new label so old marks cannot be mistaken for the current assignment.
If trays are sometimes stacked before the label comes off, include that step in the second trial. Check whether the sample ID remains readable and whether the upper tray pushes against the label. Record the result with the planned removal time.
For labels that need to move instead of being replaced, see the repositionable bin label guide.