Skip to content
Cart
← The DSC Journal

Checking sticker adhesion on a coated paper belly band

Test the actual coating and fold, then compare the sticker on an assembled band and a flat control.

Coated paper band adhesion
Davao Sticker Custom

Identify the coating that meets the adhesive

Take a band from the production stock and mark the finished side and the overlap. If the supplier uses different finishes, keep a sample from each. Put a paper mockup on a wrapped item and see whether the label crosses the join or a bend. Tell the printer whether the sticker closes the band or only identifies the item. Ask for a sample and preparation method for the exact coating.

Compare the working position with a flat piece

Apply matching samples using the material directions. Put one in the approved position and one on a spare band away from folds. Give them the same wait and inspect the edges before handling. Slide the wrapped item into its box and take it out as a recipient would. Note whether the label catches on the box or lifts when the band moves against the package.

Record what happens when you remove or open the band

If the sticker needs to come off, test the approved removal method on a spare and compare the coating afterward. Check whether a mark follows the sticker or the original fold. Save the tested band, an unused piece of stock, and a photo of the position. If a second coating looks the same from the front, keep its test separate until it passes.

Check the selected sample after a typical stack of wrapped items sits in storage. A label near the overlap can lift when a second package presses against it. Record the position and keep the flat sample for comparison.

See the cardboard adhesion control test for a related check.

Request a project quote

Send the band material and show where the sticker sits on the wrapped item.

Discuss your project →