Skip to content
Cart
← The DSC Journal

How to proof a wrap with a dark roof and light body

Check the proposed color break from several angles and mark where the roof color should end at the pillars and trim.

Vehicle graphics
Davao Sticker Custom

Photograph the roof and body together

Take straight side and front corner views in daylight. Show any trim or glass between the roof and the light body color. Mark the pillars and note which pieces you want dark. If a spoiler or roof accessory is also dark, show whether you want it to blend with the roof or stand apart. Ask the designer to keep the existing trim visible in the proof.

Compare two break lines on the same photo

Ask for one version with the line close to the roof edge and another with the dark color continuing onto the part you are considering. Compare both from the side and corner. Look for light-colored slivers beside seals and areas where the dark line would stop in plain view. Ask the installer to mark the exact boundary on the same drawing.

Check the finishes under the same light

Bring the exact dark and light film samples together if both are changing. If the body stays original, review the dark sample beside the paint. Confirm how both finishes look in open shade and under a stronger reflection. Keep the sample references with the chosen artwork.

Check the rear view as its own proof

Ask the designer to show how the dark roof line meets the rear pillars or hatch. Compare the line on both sides before the installer prepares the film.

Use the selected line at pickup

Check the front and rear roof corners and both sides. Photograph the same views after installation. If an opening shows original color, record that view with the approved proof.

For specifying an unchanged roof in a quote, see the partial wrap roof quote guide.

Request a project quote

Send side and corner photos and mark the roof and body colors you want to compare.

Discuss your project →