Skip to content
Cart
← The DSC Journal

How to proof a car sticker on a curved trunk lid

Check the sticker’s shape and wording from behind and at a corner before approving the position on a curved trunk lid.

Vehicle graphics
Davao Sticker Custom

Find the area that reads straight on

Photograph the parked car from the rear and both corners with the lid closed. Mark the area where the lid turns into its sides or upper face. Show any badge, release, camera, trim, and lights that need to stay clear. Ask the designer to identify the section of the lid where the whole shape can sit.

Compare a complete proof at two positions

Have a helper hold a full-size paper sample against the lid. Look from the usual customer approach and then from both rear corners. If the sticker looks bent or one end disappears around the curve, move the full piece to a flatter position and compare again. Try a smaller logo if the available area is limited. If the lid has a centered badge, compare the logo against the badge and against the usable face. Decide which reference gives the design a clearer position from the rear.

Review the edges and the trunk’s use

Remove the sample before opening the trunk. Show the installer where hands grip or luggage passes near the lid. Ask them to confirm the film and the proposed boundary on the vehicle. Keep release access, badges you want retained, and working features clear.

Approve the shape and location together

Save the finished dimensions and measurements from two fixed points. Keep a rear-corner photo so a replacement can follow the same position. Mark which side of the sticker should face the top of the lid. If the lid changes after repair, confirm the old measurements before printing again.

Use the curved tailgate lettering guide if the same job includes a pickup.

Request a project quote

Share rear and corner photos of the closed trunk and the intended sticker size.

Discuss your project →